If an item drawing does not contain essential parameters, such as lengths for example, Lineardraft will use standard parameters instead.
Below is a list of standard parameters for items in the MTM design catalogue, that are used unless stated otherwise on the drawing(s).
Mast Lengths
Standard mast lengths of 1m-12m in 0.1m increments.
Foundation Lengths
Standard foundation lengths of 0.5m-8m in 0.1m increments.
Foundation Gap Range
Standard range:
- Minimum: 0m
- Maximum: 0.1m
- Default: 0.05m
Gantry Lengths
For TTC gantries, standard lengths of 1m-12m in 0.1m increments.
For portal gantries, standard lengths of 7m-35m in 0.05m increments.